Refrigerator ice hookup How to Connect a Refrigerator Water and Ice Dispenser

Refrigerator ice hookup

Attach the free end of the copper tubing to the valve.

Plumb the fridge

It has a tiny shutoff valve that uses a sharp pointed metal rod to pierce the outer wall of the pipe when screwed inward. How Motion-Activated Screwdrivers Work. Connect the Tee Adapter.

Saddle valve for refrigerator water line. Step 7 — Put the compression nut and ferrule onto the water tubing that came with your kit.

Required Tools for this Project

If running the refrigerator ice hookup through the cabinets is not feasible, you might need to run a line through the floor and up to where the refrigerator is located. You will need a refrigerator water line installation kit, a drill, a wrench, drill bits, a screwdriver, and a water line cutter to complete this refrigerator ice hookup. You may have three water supply lines beneath the sink; two lines connect directly to the faucet while the third line connects to the dishwasher.

Harsch received her Certified Nurses Assistant license in If you need to drill through floors or walls, check for air ducts, electrical wiring, plumbing or other possible impediments first.

Step 4 — Use the water refrigerator ice hookup saddle valve that came with your fridge water line kit and attach it to the cold water pipe using a screwdriver and the clamps it came with. Here is how to tap into the cold water pipe and get cold water to your refrigerator ice maker and water dispenser: In most cases, the water line can be run from a kitchen faucet water supply line through the kitchen cabinets and over to the refrigerator. Plug your refrigerator into the wall.

Drill/driver fitted with 5/8-inch spade bit

Watch for leaks at all the connections. Then slide on the compression fittings, lubricate the threads on the refrigerator fitting with pipe compound and screw on the tubing. Step 1 — Locate and select the COLD water pipe in the floor or wall you will be using for the fridge water line. Adapt-a-Tees can be used in many situations where you need an extra line. Once it's attached, open the new stop valve and check the entire piping system for leaks.

Anime games dating

Get the screws on the clamps tight enough until the sealing washer or gasket swells up. How Tankless Toilets Work. Run the water line into the bucket until the water is perfectly clean and clear.

Cupid rush dating site

Turn the supply line on once again. Shut off the water at the valve that controls the cold-water supply pipe to the faucet.

Desert dating

Make sure the threads are facing the end of the line.